Thread: Possible bent compressor shaft
06-26-2008, 01:14 PM #1
Possible bent compressor shaft
I have a buddy who just bought a "slightly used" Stock SC for his 06 RXP. This one had brand new Metals in it and he is to install the GreenWheel. We looked at the Drive gear when it spins and it looks like there is a slight wobble.
Could it be the shaft is bent or something else that could cause the Drive gear to not spin true. Or is it not a problem at all.
We are thinking with even an ever so slight wobble damage coud occur.
We are going to have a trained eye look at it and see what they thought, but thought I would ask here if anyone else ran across something like this.
06-26-2008, 01:17 PM #2
- Join Date
- Jul 2006
06-26-2008, 02:25 PM #3
The only other thing I can think of that would cause it to wobble would be if they didn't put all of the needle bearings in when they replaced the washers The needle bearings are between the gear and the shaft. If it is just the drive gear wobbling and you dont see the wobble at the end of the shaft were the nut is then I would say this is your problem.
Last edited by speedskixp; 06-26-2008 at 02:33 PM.
06-27-2008, 05:48 AM #4
- Join Date
- Aug 2005
- Jerry's guest bedroom
Bearings not pressed in correctly. Send it to Jerry for the wheel install and let him reinstall/replace the bearings and inspect the unit.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By DonziFreak in forum Yamaha Open DiscussionReplies: 4Last Post: 04-01-2012, 08:23 PM
By RXP rider in forum 4-Tec PerformanceReplies: 7Last Post: 06-24-2011, 07:40 PM
By jarodl in forum Polaris How To & FAQsReplies: 4Last Post: 06-18-2011, 01:06 AM
By suparoo in forum MSX/MatrixReplies: 8Last Post: 02-24-2010, 09:51 AM
By diskos in forum Sea Doo Open DiscussionReplies: 2Last Post: 12-01-2009, 02:54 PM