Results 1 to 3 of 3
  1. #1

    Join Date
    Jan 2007
    Location
    Virginia
    Posts
    277

    Re-ataching the exit nozzle

    I am going to take it off to remove the siphon and visibilty spout. What do you guys use when putting ti back on. Any silicone?


  2. #2
    Buaidh No Bas howestek's Avatar
    Join Date
    May 2005
    Location
    Louisiana
    Posts
    917
    I use a thin layer of Yamabond. I would think a good silicone will work. I know of one very fast person who doesn't bother putting anything there.
    Last edited by howestek; 06-28-2008 at 09:22 PM.

  3. #3
    Moderator OsideBill's Avatar
    Join Date
    Mar 2006
    Location
    United States
    Posts
    11,875
    +1
    30
    I seal pre pump but not post of it. So I don't seal the reduction nozzle.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. what is the exit and steerring nozzle size range differences, min and max?
    By Pale Rider in forum Yamaha PWC Performance (2-stroke)
    Replies: 11
    Last Post: 08-01-2010, 07:47 AM
  2. FORD is Re-releasing the Boss 302 BLOCK!!! YES!!
    By carbuff91 in forum Yamaha Open Discussion
    Replies: 8
    Last Post: 05-29-2007, 07:13 PM
  3. Should I re-tap the thread?
    By GeoRXT in forum 4-Tec Performance
    Replies: 11
    Last Post: 09-16-2006, 03:08 PM
  4. Exit nozzle
    By GRNGOBLIN in forum 4-Tec Performance
    Replies: 4
    Last Post: 08-30-2006, 01:45 PM
  5. Gpr exit nozzle clarification needed!
    By Mongoose in forum Yamaha PWC Performance (2-stroke)
    Replies: 17
    Last Post: 04-05-2006, 08:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •