Results 1 to 3 of 3
  1. #1
    IrishGpr05's Avatar
    Join Date
    Dec 2005
    Location
    Niagara Falls, NY
    Posts
    523

    Need A Measuremnt...

    I need to know the size of the hole on a 2.3 n/s that would be used in a set of GPR carbs. If that makes sense..if not I will try to clarify.

    -Jon


  2. #2
    Moderator beerdart's Avatar
    Join Date
    Aug 2006
    Location
    CT
    Posts
    25,930
    +1
    1,407
    I measured a 2.0 and it is 2mm So I would say that a 2.3 is 2.3mm

  3. #3
    IrishGpr05's Avatar
    Join Date
    Dec 2005
    Location
    Niagara Falls, NY
    Posts
    523
    Sounds good..thanks bro!

    -Jon

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Advice Needed
    By Fuhreal in forum Sea Doo Open Discussion
    Replies: 3
    Last Post: 06-16-2005, 02:08 PM
  2. Need some graphics
    By lawracing in forum 4-Tec Performance
    Replies: 10
    Last Post: 06-02-2005, 10:16 PM
  3. RXP Stage I parts shipped , need input!
    By Vern in forum 4-Tec Performance
    Replies: 8
    Last Post: 05-24-2005, 03:01 PM
  4. I need help remove stock intercooler
    By orc in forum 4-Tec Performance
    Replies: 3
    Last Post: 05-13-2005, 04:08 PM
  5. NEED HELP!!!!!
    By MartyRXP in forum 4-Tec Performance
    Replies: 11
    Last Post: 05-10-2005, 08:15 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •