06-30-2008, 08:58 PM #1
question for the PRO's... about PV's
What would cause the plastic coupler between PV 2 and 1 to snap in half? this happened 2 times now, back to back...
I can turn PV 1 by hand and it feels very smooth. took off the cover of PV 1 and all looked good...
06-30-2008, 09:26 PM #2
More info needed.
Year? make? model ?
GP 800 ? or what?
You mentioned PV 1 was free & easy to move- what about # 2 ?
Is it siezed up ?
My expirience on the 1200's is that they can get gunked up with 2stroke oil ?
Also- are both cable attached to the PV motor ?
And- when you start the boat for asecond- then turn it off- do you hear the PV motor run its test cycle ? IF so can you see the cables moving and verify they are both attached properly.
06-30-2008, 09:27 PM #3
06-30-2008, 09:31 PM #4
they cycle fine. since only 2-3 are hooked up, they move like they are suppose to. I put a new plastic coupler between 2 and 1 and rode for about an hour, then lost 300 RPMs I knew what it was imediatly, went to shore, and sure enough, it had broke again
06-30-2008, 10:24 PM #5
Just talked to Pistonrash about it James... give him a ring
06-30-2008, 10:34 PM #6
06-30-2008, 10:38 PM #7
You guys are just too funny...Hey Flyboy,do you need me to come over there and put that thing together so we can race...Sorry to hear it happened though,,,,,
06-30-2008, 11:46 PM #8
06-30-2008, 11:46 PM #9
only thing that comes to mind is alignment if 2-3 cycle fine how does it feel when all three are hooked up? does it have issues returning or opening?
06-30-2008, 11:47 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mrjetskey in forum 4-Tec PerformanceReplies: 6Last Post: 04-02-2013, 03:39 PM
By jkevin50 in forum Polaris Open DiscussionReplies: 8Last Post: 07-05-2010, 03:43 PM
By hitevrywave in forum Sea Doo Open DiscussionReplies: 3Last Post: 03-21-2008, 07:42 PM
By VaRedneck in forum 4-Tec PerformanceReplies: 13Last Post: 02-09-2008, 10:49 PM
By psi_2_high in forum Sea Doo Open DiscussionReplies: 5Last Post: 11-09-2007, 08:33 PM