Results 1 to 2 of 2
  1. #1

    R&D RidePlate install

    How hard should i draw the bults on the R&D rideplate (10-15NM?)... and need i adjust the reverse cabel?


  2. #2
    Take the time to smile sirbreaksalot's Avatar
    Join Date
    Jun 2007
    Location
    Brisvegas
    Posts
    4,165
    +1
    602
    Quote Originally Posted by pottzr View Post
    How hard should i draw the bults on the R&D rideplate (10-15NM?)... and need i adjust the reverse cabel?

    you will need to notch the reverse bucket.

    By that I mean when you put the ski into reverse you will see that before it locks into reverse the bucket will bottom out on the plate just near the mounting bolts area,

    toy will need to grind a section out of each side to get full travel, that will do two things,

    1 give you a better reverse
    2 allow the handle to lock into place with out adjusting

    that tension would be fine, if you can get your hands on a manual all the specs will be in there for all of the ski.


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Rideplate Installation
    By RobbieMWD in forum 4-Tec Performance
    Replies: 28
    Last Post: 01-24-2009, 09:29 AM
  2. 15f R&D rideplate install question
    By inchadeboca in forum Kawasaki PWC Performance (4-stroke)
    Replies: 1
    Last Post: 07-11-2008, 06:46 PM
  3. Rideplate install question...
    By GeoRXT in forum 4-Tec Performance
    Replies: 9
    Last Post: 08-05-2007, 02:35 PM
  4. R&D Rideplate install?
    By Suthrn in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 07-21-2006, 08:20 PM
  5. R&D Rideplate Install Instuctions?
    By Chrisrokc in forum Yamaha PWC Performance (2-stroke)
    Replies: 12
    Last Post: 06-30-2006, 09:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •