Thread: lord mounts
07-07-2008, 08:08 AM #1
where's a good place to get some for the triple pipe setup's?? j-6168-27 is what i see on the mounts
07-07-2008, 08:17 AM #2
07-07-2008, 10:27 AM #3
Or you can go the ugly expensive route and call Factory Pipe.
07-07-2008, 11:10 AM #4
are the f/p ones neoprene or rubber???
07-07-2008, 12:07 PM #5
I don't know that the neoprene would have enough "give" for the pipes, you might wind up cracking them??
07-07-2008, 01:12 PM #6
learning the hard way
wanna know how it broke???evidently when i epoxied the aluminum pedestals into the hull bottom there was enough epoxy to push up into the threaded part.no the lord mount wasn't in it.so when i did install the mount it bottomed out on the epoxy an 1/8" before seating,that caused the mount directly opposite to be drawn up with that amount of pressure until it tore apart.live and learn
07-08-2008, 03:14 PM #7
34.00 bucks apiece,and they've been discontinued.lord says they are stainless and doesn't have anything to replace them as well.ordered 4 from mcmaster.going to rob the ones from the virage,have a spare for the pro and the virage,f/p are neoprene but can only get natural in stainless thru mcmaster.went with a bigger mount to support the virage pipes
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tokeytokertin in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 01-14-2014, 11:46 AM
By 992door in forum Yamaha ClassifiedsReplies: 7Last Post: 07-28-2012, 02:57 PM
By killcraft in forum Polaris Open DiscussionReplies: 7Last Post: 04-16-2011, 01:09 PM
By Kinchyle in forum Sea Doo Open DiscussionReplies: 3Last Post: 09-01-2005, 01:03 PM
By nitro rxp in forum 4-Tec PerformanceReplies: 6Last Post: 05-13-2005, 08:01 AM