07-08-2008, 03:31 PM #1
measurements for riva rpm filter?
does anyone know these? im wanting to cheat a little and not have to spend so much money on the kit from riva. if i knew the top and bottom diameter and the length i could just order one from k&n. i plan on ordering blockoffs so i have no use for the smaller filters that are prone to break. can anyone help me out?
07-08-2008, 04:20 PM #2
it depends if your doing the "bucket" mod like JP1300, Firehawk, myself, and jtskir15f did...if you are then you need something that will fit in the bucket which you can take a few different routes with otherwise if your just bolting it on to the TB, I believe Harry-Ultra250TN is selling just the riva filter....goodluck
07-09-2008, 12:08 AM #3
i want to eventually put it in the bucket but i just want to clamp it to the throttle body for now. i assume as long i get one with the flange measuring 2.75 it will clamp to the throttle body? what size filter are you running in your bucket chris?
07-09-2008, 11:58 AM #4
I run the RX-4960...I don't think this one would just clamp on...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Extrememotors in forum Sea Doo ClassifiedsReplies: 0Last Post: 04-27-2008, 06:51 PM
By wave15stx in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 06-12-2007, 11:17 AM
By Hecyan in forum 4-Tec PerformanceReplies: 18Last Post: 07-29-2006, 04:15 PM
By RXP-REX in forum Sea Doo Open DiscussionReplies: 5Last Post: 05-29-2006, 06:39 PM
By Jrsrxp in forum 4-Tec PerformanceReplies: 1Last Post: 05-18-2005, 07:49 AM