Results 1 to 2 of 2
  1. #1
    Stop Obama Express
    Join Date
    Apr 2008
    Lexington, KY

    sharpening the pump fins...

    I was wondering if it is worth it to take a die grinder to the bronze fins behind the impeller while I have it out. It has a few blunt nicks and didnt know if i should just sharpen them all around.

  2. #2
    PEST!'s Avatar
    Join Date
    Jun 2008
    Rockledge Florida
    you might notice a difference but its long hard worrk and very little pay back I think a later plastic pump might do the same thing with less work

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Polishing the pump
    By Green Hulk in forum Yamaha PWC Performance (2-stroke)
    Replies: 40
    Last Post: 07-28-2006, 10:11 AM
  2. I took off the pump for the first time.....
    By boataddict in forum Sea Doo Open Discussion
    Replies: 23
    Last Post: 02-17-2006, 09:45 PM
  3. porting the pump?
    By Krazy-K in forum 4-Tec Performance
    Replies: 5
    Last Post: 08-30-2005, 09:42 PM
  4. How much clearance in the pump?
    By 818RXP in forum 4-Tec Performance
    Replies: 0
    Last Post: 08-07-2005, 04:53 PM
  5. Are sharks plastic fins in the pump support needed
    By macattack in forum 4-Tec Performance
    Replies: 0
    Last Post: 07-04-2005, 11:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts