Results 1 to 3 of 3
  1. #1

    Choke set screw size?

    Does anyone know the size and pitch of the little screw that holds the choke cable onto the carbs? Mine fell into the bottom of my hull and I can't find the bugger. Any help is appreciated.

  2. #2
    ph2ocraft's Avatar
    Join Date
    Apr 2006
    Campbell, Ca.
    Have you tried tipping the trailer nose up and see if the screw makes its way to the back of the hull??
    I know the hardware usually gets caught up on the ribs but sometimes a good jolt will throw that sucker all the way back.

  3. #3
    Click avatar for tech links/info, donation request K447's Avatar
    Join Date
    Jul 2007
    near Toronto, Canada
    Tip the nose way up, make sure the drain plugs are in, and try some compressed air blasts under the engine, towards the rear.

    I found a number of odd items in my hulls once I cleaned them up, and pushed the stuff towards the back. Rubber washers, bolts, nuts, circlips...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. set screws on Riva nozzle
    By dave911rsr in forum 4-Tec Performance
    Replies: 22
    Last Post: 08-03-2009, 12:19 PM
  2. Screw Size
    By mikeysso in forum 2-Stroke Performance
    Replies: 8
    Last Post: 06-11-2009, 05:55 AM
  3. jet screw sizes
    By xplayer2885 in forum Polaris Open Discussion
    Replies: 1
    Last Post: 08-15-2007, 10:50 AM
  4. Screw Size for Sponsons
    By janetmojo in forum Yamaha How To & FAQs
    Replies: 2
    Last Post: 09-05-2006, 10:55 AM
  5. Thermostat worm screw sizes
    By Kinchyle in forum Sea Doo Open Discussion
    Replies: 3
    Last Post: 06-27-2006, 08:34 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts