07-11-2008, 09:58 AM #1
15f R&D rideplate install question
i am tweaking my rideplate this weekend....sanding and mounting flush to the hull, my question is:
has anyone mounted the RD rideplate without the two rubber pieces that sandwiches between the plate and the hull up on the front of the plate? i am just going to use a nice amount silicone (right stuff) and avoid putting the rubber pieces in. it is causing my plate to hang up front on the right side and causing some drag issues.
any suggestions ?
07-11-2008, 06:46 PM #2
I left my two rubber pieces off. I couldn't get the plate on flush with them. This maybe why some people are slow. Seal the plate good all the way around and the bolt holes.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By stinkhammer in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 08-06-2013, 03:34 PM
By GeoRXT in forum 4-Tec PerformanceReplies: 9Last Post: 08-05-2007, 02:35 PM
By Vern in forum 4-Tec PerformanceReplies: 11Last Post: 07-09-2005, 09:59 AM
By Mark S in forum 4-Tec PerformanceReplies: 2Last Post: 07-01-2005, 09:25 PM
By 05Limited in forum 4-Tec PerformanceReplies: 5Last Post: 06-03-2005, 09:54 AM