Thread: Oil Sending Unit Question
07-15-2008, 11:29 AM #1
Oil Sending Unit Question
When I was changing out the oil tank due to a split in it on my 2002 GTI LS I noticed the cap on the cylinder at the bottom of the sensor is loose and not affixed to the cylinder. I might have done this when I was pulling out the sensor. Is this a problem? Will it continue to work like this or do I need to pull it all the way out, clean it and glue or epoxy it back together. It seems with the holes that are in the cylinder it would still function properly with a loose lid. Thanks
Last edited by newtball; 07-15-2008 at 06:24 PM.
07-16-2008, 07:22 AM #2
Well I threw it all back together and started the ski with just the oil that was in the lines and the low indicator light came on. Then I filled the oil tank and started again. This time no light, so I guess the loose top on the sending unit does not matter.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mrjetskey in forum Polaris PWC PerformanceReplies: 0Last Post: 10-22-2008, 10:12 AM
By mrjetskey in forum Polaris Open DiscussionReplies: 1Last Post: 09-28-2008, 05:04 PM
By newtball in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-16-2008, 07:23 AM
By redhead780 in forum Polaris Open DiscussionReplies: 4Last Post: 07-08-2008, 08:00 PM
By Tony in forum Polaris Open DiscussionReplies: 13Last Post: 07-14-2007, 07:44 PM