Thread: printing on veil (fiberglass)
07-16-2008, 10:47 AM #1
printing on veil (fiberglass)
Ran a test and printed up 9 lengths of a water pattern on veil for a waterslide project.
So thought to try out some other designs as well, just to see.
I don't know if anyone would have an application for this, however we had success in the samples seen here.
The veil was placed face down over clear gel, saturated from the back side in clear, then backed once after that with opaque white, and the heavier fiberglass layers behind that.
Figured if someone needs it, I can render it.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jawz in forum 4-Tec PerformanceReplies: 4Last Post: 02-28-2006, 10:11 PM
By WildBill9000 in forum Sea Doo Open DiscussionReplies: 25Last Post: 02-26-2006, 10:25 AM
By WildBill9000 in forum Sea Doo Open DiscussionReplies: 5Last Post: 02-04-2006, 02:21 AM
By Pale Rider in forum Sea Doo Open DiscussionReplies: 4Last Post: 11-21-2005, 09:28 PM
By Griff350 in forum Sea Doo Open DiscussionReplies: 2Last Post: 10-20-2005, 02:55 PM