Results 1 to 3 of 3
  1. #1

    Drilling 08 Exhaust Manifold For o2 Sensor

    Who has drilled the exhaust manifold, any tips also did you drill it in the boat?

    Thanks


  2. #2
    kp04rxp's Avatar
    Join Date
    Nov 2007
    Location
    Pipersville, PA
    Posts
    826
    Has this been done?? I personally do not know of a spot in the manifold which you can do this due to the water jacket....??

    Maybe in the piece that replaced the j-pipe?

  3. #3
    HORSEPOWER JUNKIE 9secZO6's Avatar
    Join Date
    Jun 2007
    Location
    Belle Chasse, La.
    Posts
    2,006
    +1
    1
    I drilled a 07 manifold, way too much material there, the tip of the sensor will not be in the direct path of the exhaust. I have not looked good at the x though

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Anyone drill and tap a 2014 exhaust manifold for O2 sensor?
    By Gus13letter in forum 4-Tec Performance
    Replies: 71
    Last Post: 04-03-2015, 01:45 PM
  2. WTB Looking for tapped manifold for o2 sensor 4 tec
    By wave15stx in forum Sea Doo Classifieds
    Replies: 0
    Last Post: 02-28-2015, 09:40 AM
  3. Tap manifold for o2 sensor, help!!
    By tocullo in forum 4-Tec Performance
    Replies: 13
    Last Post: 08-21-2014, 04:40 PM
  4. stripped threads in exhaust manifold for O2 sensor
    By mibunkerking in forum 4-Tec Performance
    Replies: 36
    Last Post: 10-25-2013, 05:19 PM
  5. FS Exhaust manifold w/ o2 sensor tapped hole
    By rxpblast in forum Sea Doo Classifieds
    Replies: 7
    Last Post: 10-19-2010, 11:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •