07-19-2008, 08:59 PM #1
jetworks flow valve before waterbox
mostly used on 2 strokes, but if i put one on my 250 it should help right? probably not much, but every bit helps right! i would also be worried about the eng temp. cause it runs to hot as is and i don't want to make it worse, what do ya think?
07-19-2008, 09:06 PM #2
good call on the engine temp.... i wouldn't do it if it risked more heat in the motor..... the only thing that is going to do is slow you down from heatsoke and what not
07-20-2008, 01:39 PM #3
i wonder if i could route the water out but split it to the water box and reduce the size of the exit on the bypass to let it build enough pressure to push open the valve but still not reduce h20 flow out of motor? then i would have to make sure the boxes are getting enough water as to not burn the couplers up. there are 2 small hole that pour water into the box from the exhaust and those will never be blocked. what are your thoughts?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By x2ryder in forum Kawasaki ClassifiedsReplies: 0Last Post: 01-17-2011, 02:18 PM
By skigolfnut in forum Polaris Open DiscussionReplies: 19Last Post: 04-08-2010, 10:29 PM
By kccoltn in forum Polaris PWC PerformanceReplies: 0Last Post: 08-14-2009, 01:37 PM
By gordon lasiter #328 in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 10-16-2008, 02:39 PM
By ZMANN in forum Polaris PWC PerformanceReplies: 19Last Post: 01-10-2007, 12:32 PM