Thread: Pump Shoe Sealing
07-21-2008, 07:02 PM #1
Pump Shoe Sealing
Anyone every have the problem with the PPKs sticking to the hull instead of in the pump shoe? Mine are now stuck to the damn hull and won't come off unless I rip them off.
Anyways I guess I have two options.
Buy a new PPK
Do some custom work of some sort and fill the damn thing
07-21-2008, 07:13 PM #2
If you dont wanna do that, you can do a DIY...
On my dad's FX, I used The Right Stuff (or maybe good stuff? its the foam stuff) to fill the voids. Trim it a bit below the top of the void, and seal on top with 5/4200.
07-21-2008, 07:14 PM #3
07-22-2008, 07:19 AM #4
Maybe get some thin wire under the stuck plugs and pull it tight to separate the plug from the hull? It may be easier than using a blade, with less chance of damaging the plug or hull...
07-22-2008, 07:48 AM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By COUJAR in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 05-20-2008, 03:12 PM
By Pistonwash in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 03-01-2008, 10:13 PM
By Full_Throttle in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 02-29-2008, 12:12 PM
By ercBOOSTED in forum Kawasaki PWC Performance (4-stroke)Replies: 11Last Post: 07-16-2007, 07:15 PM
By earthshaker in forum Kawasaki PWC Performance (4-stroke)Replies: 9Last Post: 06-04-2007, 11:44 AM