Results 1 to 2 of 2
07-26-2008, 03:58 PM #1
Modifying a Jet Ski Trailer to Carry a Motorcycle
I am looking to put a single channel on my ski trailer so that I can move one of my bikes. The TT500 doesn't weigh too much, so I'm not worried about overloading the trailer. A friend is going to cut/weld a channel so that I can position it on the trailer to maintain a good load on the tongue. The only thing that I seem to need is spacers in between the bunk brackets where they taper so that the channel is firmly supported on the trailer. I will also have a loading channel that interlocks to the main channel for loading & unloading. Any recommendations/comments? TIA... Ron
07-26-2008, 05:48 PM #2
This is what Loadrite uses for thier motorcycle trailers. It's a Pwc base trailer with pans.
To modify yours. You can use a 2x6" or 8" wood plank and mount it through the crossbars using lag bolts to get a flat solid base for the pans.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Paul2005GPR in forum Towing and TrailersReplies: 3Last Post: 08-27-2011, 08:24 AM
By Paul2005GPR in forum Trailer ClassifiedsReplies: 1Last Post: 08-17-2011, 11:04 PM
By Cliffy in forum Polaris Open DiscussionReplies: 19Last Post: 12-30-2009, 05:40 AM
By junior in forum 4-Tec PerformanceReplies: 5Last Post: 08-17-2007, 04:21 PM
By txgp1300r in forum Yamaha Open DiscussionReplies: 4Last Post: 06-27-2006, 07:46 AM