Results 1 to 2 of 2
  1. #1


    Need to have a little mill work done to a 717 Exhaust Manifold to mill a flat area on the sides,, between the mounting bolt galleries to install a NPT fitting for EGT Probes.

    There is very little room for error to avoid cutting into the water jacket so you will need to set up the irregular shaped Ex. Manifold on the Mill Table to make a precise cut. FIRST TIME.........

    e-Mail me if you can do this small job with a reasonable set up fee.
    I can provide the correct diameter cutting tool and ship you the Manifold.



  2. #2
    Master of the Dooniverse
    Join Date
    May 2006
    Schenectady, Ny
    Man, I can do that chit with ym eyes closed DvD.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. SOLD Solas DynaFly Impeller KG-DF 12/24 - Very Good Condition
    By drb in forum Sea Doo 2 Stroke Skis
    Replies: 7
    Last Post: 10-01-2010, 12:38 AM
  2. WTB need a very good machine shop!!!!
    By slydogge in forum Yamaha Classifieds
    Replies: 13
    Last Post: 09-16-2010, 09:28 PM
  3. Looking for a very good machine shop
    By slydogge in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 09-16-2010, 03:48 PM
  4. FS Solas DynaFly Impeller KG-DF 12/24 - Very Good Condition
    By drb in forum Kawasaki Classifieds
    Replies: 0
    Last Post: 08-15-2010, 10:08 PM
  5. Very Good Beatboxing...
    By Danny in forum Videos & Pictures
    Replies: 3
    Last Post: 01-04-2008, 04:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts