07-27-2008, 01:33 AM #1
Is 14/19 good match for Stage 1 '03 SC?
Hey guys - will this fit my '03 SC w/ a skat pump and is it a good match for stage 1 mods on same?
07-27-2008, 05:39 AM #2
DOH - Nevermind! I guess it does since it's in the Stage 1 kit! Nevermind/sorry guys
... actually the 13/20 is in the GTX SC Stage 1 kit isn't it !!??
Last edited by GTXDawg; 07-27-2008 at 07:03 AM.
07-27-2008, 06:52 AM #3
- Join Date
- May 2005
- Louisville KY.
No it will not fit. The splines on your drive shaft are smaller. Even if it did fit you don't have the power to spin that prop. What you need is a 12/20 and you will still need to tweak it a little to get max rpms.
07-27-2008, 07:07 AM #4
Thanks Trimer - I finally got a metal pump (housing # 267 000 046 off a 2006 RXP - will have to swap wear rings is all I think) - w/ a triple bearing skat conversion as well - for my 03 SC and now not sure what impeller to add when I replace it this winter.
... not planning to add anything major to it - 4" air, gibson, new thru hull exhaust
Last edited by GTXDawg; 07-27-2008 at 07:11 AM.
07-27-2008, 03:07 PM #5
I will be adding the 14/19 with the RXT driveshaft and ss wear ring, along with the 8100 ECU, knock sensor and 58 fpr to spin it. Keep an eye on "jpeconsult's 185 build"
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By theantiRXP in forum Sea Doo Open DiscussionReplies: 2Last Post: 05-01-2006, 09:45 AM
By LiquidDI in forum Sea Doo Open DiscussionReplies: 7Last Post: 03-10-2006, 01:17 AM
By Water4fire in forum Sea Doo Open DiscussionReplies: 1Last Post: 01-14-2006, 11:48 AM
By rxp_boy in forum 4-Tec PerformanceReplies: 9Last Post: 08-13-2005, 01:18 AM
By kenshin89 in forum 4-Tec PerformanceReplies: 5Last Post: 08-08-2005, 08:01 AM