Results 1 to 1 of 1
  1. #1

    xl1200 bile pump install

    Ok so I've rebuilt my ski and its been running great for about six weeks. I just installed a bilge pump in my superjet and was thinking of doing the same for my xl. After having the ski sink, I really don't want to go through that again. Even though Ive repaired all leaks I figure a bile pump is cheap insurance.

    Was thinking of mounting it right behind the firewall to one side of the pump tunnel. I would put a through hull right out the back. The pump I would use is a RuleMate 500gph. It was a float switch built in so it won't run unless there is water. Won't kill the batt that way and I don't have wire in a switch.

    Has anyone installed such a pump on an xl? What r ur thoughts?
    Last edited by ticega306; 07-28-2008 at 05:51 PM. Reason: I called it a BILE pump how do I edit the title??

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. RXP Bilge Pump install
    By Vern in forum 4-Tec Performance
    Replies: 14
    Last Post: 08-27-2014, 10:04 AM
  2. XLT Bilge Pump Installation (Pics included)
    By PWCManiac in forum Yamaha How To & FAQs
    Replies: 8
    Last Post: 08-02-2011, 07:35 PM
  3. XL1200 pump install
    By Glenn Briglio in forum Yamaha Old School Skis
    Replies: 10
    Last Post: 04-01-2010, 10:01 PM
  4. RXP bilge pump install
    By The Bandit in forum Sea Doo Open Discussion
    Replies: 73
    Last Post: 08-07-2007, 06:41 PM
  5. Pump install question.
    By Mark S in forum 4-Tec Performance
    Replies: 2
    Last Post: 07-01-2005, 09:25 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts