Thread: 2000 gpr - overhauled!!!
07-29-2008, 03:23 PM #1
2000 gpr - overhauled!!!
I bought the ski last summer for 2000 dollars, added works intake grate, pump seal, jet works, relocated battery, rebuilt/rejetted carbs, d-plate, mats, paint, new rails, mline seat cover, bildge pump, fly handlebars, gear oil in pump, and alot of other little stuff..nothing done to motor...wanted it set up for rough water...so i left the stock plate on.
ran it on gps it was getting 68.3 at 7100 rpms...
what does every body think i need to get to 70.....im thinking one of Jims plates...head..
07-29-2008, 03:25 PM #2
07-29-2008, 03:31 PM #3
Reeds, milled head, flame arrestors and an 05 pump should get you there. Depending on your jetting, you should have enough power to spin a 14/20 dynafly.
07-29-2008, 05:07 PM #4
07-29-2008, 05:15 PM #5
not bad for stock ride plate !
good job on your build
07-29-2008, 06:05 PM #6
07-29-2008, 09:04 PM #7
Don't spend another dime on that thing ,
the next time I pass you by I'm throwing
you my tow rope and I'm pulling you
07-29-2008, 09:12 PM #8
i never see you out there anymore, where you been hiding??
07-29-2008, 09:27 PM #9
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By shooter98xpl in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 11-27-2006, 09:51 PM
By dguille in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 11-26-2006, 12:15 PM
By Soto in forum Yamaha Open DiscussionReplies: 1Last Post: 10-22-2006, 07:33 PM
By shooter98xpl in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 09-01-2006, 05:52 AM
By shooter98xpl in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 12-05-2005, 08:53 PM