07-30-2008, 10:13 PM #1
- Join Date
- Mar 2008
stock jetting specs for 98 slxh 1050
Hello, this is my first post in this forum...
I have a 98 slxh 1050 that seems to have a carburation problem: will not hold a idle in the water for long, and bogs down when grabbing the throttle. The ski also will sometimes stall when letting off the gas after riding it hard. I will be swapping out the grey fuel lines shortly, as well as going through the carbs. What I'd like to know is what are the stock specs for the carbs for the low and high screws for the center, mag, and pto? Also, is there anything else I should be looking for when diagnosing this?? IE does the 1050 have any quirks I may need to know?
The compression is good in all three jugs (135-140).
Thank you for any help offered
07-31-2008, 08:14 AM #2
i got the specs at home can get later,main thing with the stock carbs is the adjusters between carbs are plastic,over time they wear and the cen carb closes a little and the pto carb closes a little more,seems every time i come across this issue i resync the carbs and bingo the thing idles again,can get the low speed adjustment for you as well,would be after 800 tx time though
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mx595 in forum Polaris Open DiscussionReplies: 14Last Post: 09-26-2008, 03:45 PM
By Itowpolarismatrix in forum 2-Stroke PerformanceReplies: 1Last Post: 08-19-2008, 06:17 PM
By philip_gpr in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 07-05-2008, 04:19 PM
By izz0 in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 03-21-2008, 05:04 AM
By ATSAaron in forum Polaris Open DiscussionReplies: 1Last Post: 07-06-2007, 10:18 PM