Results 1 to 4 of 4
  1. #1
    The powder Man!! ashelgren's Avatar
    Join Date
    Jun 2008
    Location
    Geigertown , Pa
    Posts
    166

    Unhappy How to check a vts motor??

    My VTS is not working when I push on the down button it makes a hum but it won't move. I cut the connectors off and hooked the wires together thinking it was my connectors no diff. then I checked the fuse all are good. Is their any way to make sure the motor is good or bad??
    Thanks


  2. #2

  3. #3
    The powder Man!! ashelgren's Avatar
    Join Date
    Jun 2008
    Location
    Geigertown , Pa
    Posts
    166
    Thanks man I'm going to give it a try I have a few elect. friends to do all the ohm and amp readings. The post is great good thing the vts stuck all the way up right wear I like it. I will let you know what it was when I find out it might help someone

  4. #4
    The powder Man!! ashelgren's Avatar
    Join Date
    Jun 2008
    Location
    Geigertown , Pa
    Posts
    166
    Well i made a little progress I took the motor out and checked to see if that was bad by hooking it up to a battery it would not spin so I got my plyers out and turned the gear. What do you know it was stuck now the motor turns both ways when hooked up to the battery but when I put it back together and hit the vts down all good but now it won't go up so I reverse the wires and hit down nozzle came up. so maybe its a bad switch I have to look into that now.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. how to check if a motor can run or is good - 4stroke
    By taillight in forum Sea Doo Open Discussion
    Replies: 4
    Last Post: 07-27-2015, 07:47 PM
  2. How to check the Exhaust Pipe orifice on the Domestics motors
    By CrazyA in forum Polaris How To & FAQs
    Replies: 14
    Last Post: 07-09-2012, 10:01 AM
  3. How to check for gas in oil?
    By Hecyan in forum 4-Tec Performance
    Replies: 9
    Last Post: 03-14-2007, 07:06 PM
  4. How to Check Impeller Pitch With Pitch Guage
    By johnD in forum 4-Tec Performance
    Replies: 4
    Last Post: 05-04-2006, 07:28 PM
  5. ??? How to check my charging system??
    By jitees in forum 4-Tec Performance
    Replies: 2
    Last Post: 03-31-2006, 01:56 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •