08-12-2008, 05:56 PM #1
Question for the machinist/parts guru
Ok, I got the fittings drilled tapped and installed. Now I have a question. Would I benefit from removing the area marked in red to get a more even cooling flow from the jug, or would this make the adapter too weak?
08-12-2008, 06:09 PM #2
08-12-2008, 06:29 PM #3
Leave the material if you remove it the center will fall out.
08-12-2008, 07:31 PM #4
- Join Date
- Jul 2007
- Cedar Rapids,Iowa
The material there also helps the gasket stay pinched to keep the water out of the cyl. Why do more work,every one out there is running that way with no problem.
08-12-2008, 08:01 PM #5
Works for me.
Verdict: Leave it be.
08-12-2008, 08:36 PM #6
- Join Date
- Oct 2006
- Cleveland OH
I have a couple that are "plowed" about 1/8" and some that aren't. When I spoke to Joby about this, he said it made no difference either way.
Did you research the fitting location? It may interfere with the pipe if placed wrong.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MyYammi56 in forum Yamaha How To & FAQsReplies: 6Last Post: 09-10-2010, 08:24 PM
By MyYammi56 in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 09-06-2010, 05:58 PM
By Green Hulk in forum Yamaha PWC Performance (2-stroke)Replies: 112Last Post: 12-03-2009, 02:58 AM
By hydrojunkie in forum 4-Tec PerformanceReplies: 13Last Post: 12-31-2007, 09:09 PM
By Therock in forum 4-Tec PerformanceReplies: 3Last Post: 05-20-2005, 07:13 AM