Results 1 to 3 of 3

Thread: water in bilge

  1. #1

    water in bilge

    I found the way water is getting into the bilge of my '98 XPL. There is a 3/16" hole on the right side of the transom nozzle plate, just below the steering cable. No hose is attached to it from inside. Should there be; or, should it be plugged?

  2. #2
    PEST!'s Avatar
    Join Date
    Jun 2008
    Rockledge Florida
    There should be a clear vinyl hose from a fitting on the lower edge of the cylinders on back side it goes to the nipple you talk about. Its hard to see on the engine its under the lower pipe mount . I often forget to hook it up when installing the engine.

  3. #3
    Thanks. Is that the "low point drain tube"? If so, appears to be missing!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Wavejumping/Water in Bilge
    By SolMan in forum Sea Doo Open Discussion
    Replies: 3
    Last Post: 10-06-2013, 08:30 PM
  2. Water in Bilge - 1997 GSI
    By DJD in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 08-27-2011, 08:55 AM
  3. RXP/T pump/bailer/bilge water leak ... read this
    By Vern in forum Sea Doo Open Discussion
    Replies: 9
    Last Post: 06-17-2010, 11:24 PM
  4. Water in the bilge
    By bruinsrme in forum Sea Doo Open Discussion
    Replies: 2
    Last Post: 09-27-2007, 02:09 PM
  5. Hot water in bilge
    By JimC in forum 4-Tec Performance
    Replies: 8
    Last Post: 05-29-2007, 01:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts