Thread: head question
12-07-2005, 08:45 PM #1
well a gpr1300 riva head work on a 1200 gpr motor?
12-07-2005, 10:11 PM #2
12-07-2005, 10:18 PM #3
Give a day or two. Not sure anyone knows. I know the water jackets are SIMILAR but not IDENTICAL. The way Fernando explained it to me, is that the R/D head has so much "flat area" around it, that they might fit.
If I had to guess, I'd say the 13r head would fit both. Dunno.
12-08-2005, 06:26 AM #4
well thats a 50/50 chance, thanks for the response. Anyone 100% positive?
12-08-2005, 08:34 AM #5
- Join Date
- Nov 2005
The cast Riva 1300 and 1200 are identical except for dome size of course. The cooling holes are the same on both heads. The gasket is what determines how the water flows into the head. If your boring the 1200 out to 1300 then you can use the 1300 head.
12-08-2005, 09:52 AM #6
Hey Shooter...I knew KNR had some heads and that you were looking, so I ask around a week ago. The heads will fit, but the inside diameter between the step is 84mm. Your piston is 80mm. The squish would be quite large. Everyone I talked to said "they wont work" or "dont use them".
12-13-2005, 11:18 AM #7
I assume this is the "step" you are referring to. This is an R&D 45cc head. The measurement is 84mm.
12-13-2005, 11:22 AM #8
BINGO...That is a 1300 head
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By delagem in forum Kawasaki Open DiscussionReplies: 1Last Post: 02-09-2007, 11:34 AM
By r33pwrd in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 12-10-2006, 10:20 PM
By absentx in forum Polaris PWC PerformanceReplies: 8Last Post: 09-05-2006, 04:23 AM
By washingtonrider in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 08-08-2006, 02:24 PM
By shooter98xpl in forum Yamaha PWC Performance (2-stroke)Replies: 12Last Post: 12-19-2005, 10:24 PM