08-19-2008, 10:28 AM #1
Sorry for asking an off subject question in this thread, but where did you get those adapters for the pissers? Can they be purchased somewhere?
08-19-2008, 10:55 AM #2
Those are factory for the Octane and still available through Polaris but they are pricey!! I have them fo 22 bucks each.
FITTING-FLANGE (5133642) $37.13
Last edited by ph2ocraft; 08-19-2008 at 10:58 AM.
08-19-2008, 12:51 PM #3
Try this link
Not sure if FLJOYRIDER is still making these, but they work great on mine. He ships with a ORING, but I could not get it to seat on my heads. so i made a gasket and used Lithium grease to seal
08-19-2008, 12:53 PM #4
08-19-2008, 02:40 PM #5
08-19-2008, 02:43 PM #6
08-19-2008, 02:49 PM #7
Just 7, you can get the brass fitting from any hardware store.
the units joyrider manufactured are for the Fuji engine.
You can also just tap the domestic domes for the pissers as well.
08-19-2008, 02:56 PM #8
Thanks for moving the thread Al. I think I'll just tap the domes, thanks for the info!
08-17-2009, 04:54 PM #9
I cannot find a source for the thru hull pisser fittings. Can someone help?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 11-23-2012, 03:59 AM
By K447 in forum Polaris Open DiscussionReplies: 6Last Post: 06-20-2012, 05:54 AM
By 800AMSOIL4U in forum 4-Tec PerformanceReplies: 26Last Post: 06-18-2011, 02:47 AM
By seaobin in forum Polaris Open DiscussionReplies: 7Last Post: 07-21-2010, 11:03 PM
By Dockside in forum Videos & PicturesReplies: 10Last Post: 08-20-2009, 04:40 PM