Thread: Painting inside of the hull
08-20-2008, 09:21 AM #1
Painting inside of the hull
So all of the GPR hulls look terrible on the inside to start. I saw Shibby's and simply dont have the skills/budget to do that. I saw GPRXP Steves and hydroJunkies that was proffesionally done and that is not in the budget.
Anyone use something other than an automotive type paint ?
I did see where the adhesion promotorers (bulldog and plasti-kote) will allow the paint to stick but can any rattle cans hold up to the oils etc.. ?
I checked on urethane bed liner coatings but its going to add 25lbs to the ski.
Last edited by mrbtd; 08-20-2008 at 09:55 AM.
08-20-2008, 10:56 AM #2
08-20-2008, 11:19 AM #3
- Join Date
- Nov 2007
- Odessa, TX
08-20-2008, 12:41 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By IrishGpr05 in forum Conversion PWC Performance SkisReplies: 8Last Post: 04-30-2008, 06:42 AM
By IrishGpr05 in forum Yamaha Open DiscussionReplies: 18Last Post: 04-29-2008, 10:29 PM
By mrbtd in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 03-26-2008, 08:06 AM
By seaobin in forum Polaris Open DiscussionReplies: 10Last Post: 07-29-2007, 10:50 AM
By Shibby1485 in forum 4-Tec PerformanceReplies: 16Last Post: 01-28-2006, 05:52 PM