08-22-2008, 07:26 PM #1
really need some electrical help!!
Im installing a vts system in a 2006 RXT, Im looking for the wiring schematic..
mainly where the wire goes into the mpem plug for the 7.5 amp fuse..I have looked at the 07 but Seadoo changed up the mpem and ecu wiring, and the 05 are different also..
08-22-2008, 11:08 PM #2
08-22-2008, 11:14 PM #3
- Join Date
- Nov 2007
- Odessa, TX
I thought I would try and find a shop manual at PWCToday, but they only have 05 and 07 not 06.
The cheapest I found on the internet is $5.99
The bad part I'm not 100% sure that will even help you.
Last edited by DarthAWM; 08-22-2008 at 11:29 PM.
08-23-2008, 05:25 PM #4
thanks for trying..
I think i figured it out...I check the pins with an ohm meter and found two pins that are connected to the non powered side of the 7.5 fuse..so im guessing
if i plug the wire into one of those pins i should be good...
now to figure out how to wire into the ecu..i looked at the 07 and the 08 and they match on which wires go into which pin numbers...so im guessing the 06
is the same..
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By flipsfzr in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 03-27-2012, 08:05 AM
By spannerspencer in forum MSX/MatrixReplies: 27Last Post: 01-07-2011, 03:56 AM
By verrettej in forum Polaris How To & FAQsReplies: 4Last Post: 08-08-2008, 12:44 AM
By smokey212 in forum 4-Tec PerformanceReplies: 7Last Post: 05-13-2008, 05:53 AM
By mikegpr03 in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 06-19-2007, 11:17 PM