09-04-2008, 07:16 AM #1
Suggestions For Exit & Steer Nozzles For A GSX LTD
Guys got me new toy home will post pics soon. 99 GSX LTD with 71hrs yes its true 71hrs the thing is a Virgin.
Setting up the ski for the surf for free styling and wave jumping i am adding a SKAT 13/20 SWIRL WHAT exit and steer nozzles sizes do I need for this combo.
09-07-2008, 01:35 AM #2
i would buy the wet wolf freestyle cone and use a GTX or a rfi 3D venturi/steering nozzle would be even bigger then a gtx for bottom and mid range push
imo the dynafly had a little better bottom in my old xpl then a skat but you have one of the better bottom end impellers. i'd also look for a scoop grate if just jumping, freeriding
don't forget to put that thing on a diet and throw out all the dead weight...... like resonator, waterbox foam was on a 99gsx i think and anything else
09-07-2008, 02:51 AM #3
Thanks what year model GTX should i be looking out for.
I have a WORXS Grate coming soon with a UMI set up.
I ve heard that the SOLAS Prop where good for bottom end power as well but then again i hear just leave stock impeller its a close as you can get to a SKAT Swirl.
So is it going to be a SKAT SOLAS or OEM no idea
09-08-2008, 08:00 PM #4
since your in sydney which is not exactly the land of abundant parts you might try boring your stock venturi and steering nozzle about 2mm each. or just order a wet wolf freestyle cone - cheap, bruce will ship to Australia and small part will be cheap plus you can unbolt if you don't like. that cone opens up the end of pump a lot.
i like bottom end over top for the way i ride. not sure how you funds are but imo - 1. head to bump compression - milled oem or miller/ada 2. impeller/cone upgrade. 3. reeds. 4. scoop grate 5. 951 di waterbox 6. ignition upgrade.
keep a good wear ring in and make sure carbon seal and pump shoe are air tight.
imo - the two bottom end impellers are the dynafly 13/19 and solas 13/20 better then stock.
09-08-2008, 09:00 PM #5
We can get a a far amount of parts here in Australia just need to know who to ask.
What year GTX should i be looking out for and what size venturi and nozzle
09-08-2008, 09:07 PM #6
have you seen bruce's cones??
09-09-2008, 04:58 AM #7
That would be great if you can found you old records of with bore sizes.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Boater Bob in forum Polaris ClassifiedsReplies: 1Last Post: 06-25-2008, 10:57 AM
By boconnor811 in forum Yamaha ClassifiedsReplies: 10Last Post: 06-06-2008, 07:32 PM
By 2006 RXT in forum Kawasaki PWC Performance (2-stroke)Replies: 8Last Post: 04-26-2008, 05:32 PM
By Pale Rider in forum Yamaha PWC Performance (2-stroke)Replies: 20Last Post: 01-13-2008, 07:09 PM
By Pale Rider in forum 4-Tec PerformanceReplies: 13Last Post: 12-09-2005, 06:48 PM