Results 1 to 5 of 5
  1. #1
    camar0's Avatar
    Join Date
    Apr 2007
    Location
    Sunshine
    Posts
    787

    how many quarts for motor?

    just removed oil and replaced filter

    i put back in 2.5 quarts so far

    how much more do i need to do?


  2. #2
    King_Of_Fun's Avatar
    Join Date
    Jul 2007
    Location
    Catawba Island, Ohio
    Posts
    2,703
    That depends on how much you removed. Did you crank the engine over in "drowned mode" a few times while you were siphoning the oil? If not, you didn't get out all the oil that you could have got out. Just measure what you removed and replace that amount. Don't forget to check the oil level in the correct way after you change it... Ron

  3. #3
    Nothin' better than Doo'in it! BigDaddyRXP's Avatar
    Join Date
    Aug 2007
    Location
    Tampa Bay, FL
    Posts
    9,202
    +1
    673
    Quote Originally Posted by camar0 View Post
    just removed oil and replaced filter

    i put back in 2.5 quarts so far

    how much more do i need to do?
    Mine normally hold 3.5 after change! Depends on how much you got out. If you did the change as required... you should need around 3.5, but DO NOT overfill!!!

  4. #4
    Tom Clarke's Avatar
    Join Date
    May 2005
    Location
    Surf City, California
    Posts
    274
    Anybody know how much to put in after completely draining the oil by removing the PTO housing as well as the front scavenger oil pump?
    T C

  5. #5
    Nothin' better than Doo'in it! BigDaddyRXP's Avatar
    Join Date
    Aug 2007
    Location
    Tampa Bay, FL
    Posts
    9,202
    +1
    673
    Quote Originally Posted by Tom Clarke View Post
    Anybody know how much to put in after completely draining the oil by removing the PTO housing as well as the front scavenger oil pump?
    T C
    Just enough to get it a third to half way up the stick

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How many hours for a dealer to pull a engine and clean it
    By travis ingram in forum 4-Tec Performance
    Replies: 16
    Last Post: 07-01-2014, 01:02 PM
  2. Rebuild SC at how many hours for 2012 Yamaha FZS and rebuild motor or other issues??
    By williamsrt in forum Yamaha PWC Performance (4-stroke)
    Replies: 6
    Last Post: 09-12-2013, 07:29 AM
  3. How many shims are too many for motor?
    By sweetbats in forum 4-Tec Performance
    Replies: 3
    Last Post: 07-23-2010, 01:08 PM
  4. how many quarts of oil does the sho hold
    By wave15stx in forum Yamaha Open Discussion
    Replies: 3
    Last Post: 04-20-2010, 06:05 AM
  5. How many hours for skat modded pump?
    By Pale Rider in forum 4-Tec Performance
    Replies: 1
    Last Post: 08-04-2007, 09:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •