Thread: Removing Wear Ring
09-17-2008, 11:33 PM #1
Removing Wear Ring
So i have the pump out with the wear ring still inside, really scratched up and i saw light when prop was installed...
so from what i read i just put the pump in the freezer and when i take out i should just be able to pull the wear ring out...
How long does it need to be in the freezer?
should the new wear ring also be put in the freezer before install?
09-17-2008, 11:37 PM #2
from a half hour to an hour should work. You will be suprised how easy it comes out...
09-17-2008, 11:39 PM #3
you have a lot of work done to your ski, and you have never done a wear ring before?
09-17-2008, 11:45 PM #4
Groovy is right, an hour should do it.
BUT... if it is still stubborn, leave it in overnight and then wack the edge of the wear ring in several places with a rubber mallet (or plastic handle of a large Craftsman screwdriver)... that should free it up.
09-18-2008, 01:03 AM #5
i never had to do prop work b4 and now im getting into it
09-18-2008, 07:08 AM #6
Dont forget to put the new wear ring in the freezer also
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By NoxImus in forum 4-Tec PerformanceReplies: 5Last Post: 07-22-2013, 04:21 PM
By CZSteve in forum 2-Stroke PerformanceReplies: 8Last Post: 06-16-2013, 09:59 PM
By Shibby1485 in forum Sea Doo How To & FAQsReplies: 138Last Post: 10-13-2012, 12:42 AM
By Red Devil in forum 4-Tec PerformanceReplies: 40Last Post: 08-13-2007, 07:25 PM
By watermedic in forum Sea Doo Open DiscussionReplies: 6Last Post: 05-18-2005, 09:12 AM