Results 1 to 6 of 6

Thread: d plate

  1. #1

    Join Date
    Dec 2005
    Location
    australia
    Posts
    16

    d plate

    what is the resistor value that is pluged into the cat temp sensor when you fit a d plate


  2. #2
    ABBOTT's Avatar
    Join Date
    Jul 2005
    Location
    Birmingham, AL / Lay Lake
    Posts
    3,736
    +1
    96
    i believe its 10K Ohm ---someone correct me if this is not correct. I will look in my 03-04 GPR Manual to see if its there for those two models.

  3. #3
    1000 ohms

  4. #4

    Join Date
    Nov 2005
    Location
    All over
    Posts
    716
    I used a 10k ohm and it works great! (Radio Shack $1 for 5)

    The manual will not it, it will have a range. The temp probe is variable... I believe the range is always higher the 1k ohm.

    You can always mesure the temp probe and see. I would try and heat it up first and then use an ohmmeter and see what it reads. If you do, either run it on the hose for a few or test it on the water when it's at operating temps.

  5. #5
    Happily Self-Employed WFO's Avatar
    Join Date
    Nov 2005
    Location
    Houston, Texas
    Posts
    12,801
    +1
    450
    I used a 10k ohm for the catalytic and water temp sensors.

  6. #6

    Join Date
    Dec 2005
    Location
    australia
    Posts
    16
    thanks i will get into tandy and get 1 to day

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Lets discuss ride plate extensions..........
    By SKR8PN in forum 4-Tec Performance
    Replies: 26
    Last Post: 07-01-2005, 11:56 AM
  2. Do the Riva and Worx sponsons use the same backing plates?
    By Jarrett in forum 4-Tec Performance
    Replies: 1
    Last Post: 06-29-2005, 03:03 PM
  3. Rxp ride plate mods
    By Krazy-K in forum 4-Tec Performance
    Replies: 8
    Last Post: 06-21-2005, 05:10 PM
  4. IC Block off plate - install help??
    By Vern in forum 4-Tec Performance
    Replies: 3
    Last Post: 06-02-2005, 10:34 PM
  5. OPAS BLOCK OFF PLATES AND OTHER ??
    By RXPNJ in forum 4-Tec Performance
    Replies: 4
    Last Post: 05-10-2005, 07:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •