Thread: Intake heat spacer
10-06-2008, 01:14 AM #1
Intake heat spacer
If you have done this to your 15f, how did you like it? Easy to install? Cost?
What kinda gains in speed, acceleration, rpm (bars past 7k)?
Does it say anywhere how much more hp it should yield? Thanks!
10-06-2008, 12:09 PM #2
10-06-2008, 12:45 PM #3
10-06-2008, 03:56 PM #4
as far as i know the rogue racing heat barriers are the only ones around. the website states a hp gain - but i am unsure of the benifit vs. the cost.
maybe as a last resort after a true cold air intake (rear bucket).
10-06-2008, 07:39 PM #5
I have one installed on my 250, I know before I installed it the Inake manifold was very warm to the touch after running, after install it didnt seem as warm......... as they as for every 10* temp drop you gain one horse power, and it is supposed to drop the intake manifold temp by 20 *.............kinda hard to measure 2 hp with out a dyno...............
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By grantuk in forum Sea Doo 2 Stroke SkisReplies: 1Last Post: 03-03-2013, 12:51 PM
FS - Parts Intake manifold spacers NEW - $50 shippedBy vshockey10 in forum Polaris ClassifiedsReplies: 0Last Post: 02-12-2013, 05:46 PM
By tmg97gp in forum Yamaha ClassifiedsReplies: 5Last Post: 09-28-2012, 09:38 AM
By RonJon in forum Kawasaki PWC Performance (4-stroke)Replies: 1Last Post: 07-08-2010, 11:06 AM
By Tontsa80 in forum Yamaha Old School SkisReplies: 3Last Post: 05-31-2010, 11:50 AM