Thread: 4" kanoflex help??
10-06-2008, 07:46 PM #1
4" kanoflex help??
Just installed my new intake and was wondering if there is supposed to be a clamp at the supercharger and the filter cause mine did not come with one ( guessing there is suppose to be) also came with a bracket for the filter I am guessing and was wondering if anyone had a pic of where it is supposed to brace to and where...Also what am I to do with the thermostat hose that was connected to the riva intake pipe right before the filter??? And also when I start it now the warning signal for high temp comes on and it is only at 60 according to the gauge?? Anyhelp will be great....Thanks again...
10-06-2008, 09:40 PM #2
10-07-2008, 07:01 AM #3
If you are refering the E-Temp on the the cluster, that's for Environmental Temp - air temp. If you are getting a High Temp alarm, you probably knocked off the connector on the sensor in the J-pipe... Ron
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Jrsrxp in forum 4-Tec PerformanceReplies: 1Last Post: 05-18-2005, 07:49 AM
By rxp_boy in forum 4-Tec PerformanceReplies: 8Last Post: 05-17-2005, 02:33 PM
By jonstephens in forum 4-Tec PerformanceReplies: 3Last Post: 05-16-2005, 10:47 AM
By orc in forum 4-Tec PerformanceReplies: 3Last Post: 05-13-2005, 04:08 PM
By MartyRXP in forum 4-Tec PerformanceReplies: 11Last Post: 05-10-2005, 08:15 AM