Results 1 to 2 of 2

Thread: Pump help

  1. #1

    Join Date
    Apr 2008
    New Jersey

    Pump help

    Ok I am rebuilding my jet pump in my xpl. I know to replace the wear ring, the pump to hull seal, and the carbon ring. I plan on also putting a new impeller in it. When I started pulling the pump appart I noticed some melted plastic inside the cone by the impeller. What causes that? Oil did come out of the cone when I popped the drainplug out. Also is there anything else I should replace or check inside the pump? thanks chris

  2. #2
    96XPSS's Avatar
    Join Date
    Feb 2006
    Warner Robins, GA Home of the 2007 All-Star Little League World Champions!
    If your bearings are failing it will melt the plastic that holds the bearing races in. Then you have to buy a whole pump too. If this is the case then I'd get a new pump, and just swap the pump shaft and cone out of the old one.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NoOoOo! Steering Noozle/Pump Help!
    By Sabu1984 in forum Polaris Open Discussion
    Replies: 20
    Last Post: 05-16-2008, 03:06 AM
  2. Bilge Pump help
    By jetskier90 in forum Yamaha Open Discussion
    Replies: 8
    Last Post: 03-18-2008, 06:33 PM
  3. pump help need now
    By bajaeater in forum Yamaha PWC Performance (2-stroke)
    Replies: 31
    Last Post: 01-26-2008, 12:00 PM
  4. Need to replace the pump. HELP
    By Alex Speedster 200 in forum Sea Doo Sport Boats
    Replies: 0
    Last Post: 09-12-2007, 02:50 PM
  5. More ext pump help please
    By novanuttz in forum Polaris Open Discussion
    Replies: 3
    Last Post: 06-03-2007, 02:32 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts