Results 1 to 2 of 2

Thread: REBUILD?

  1. #1

    Join Date
    Oct 2008
    Pensacola FL


    I have a 97 Wave Venture 1100 and it needs a rebuild. I was told that the #2 cylinder siezed. What is a typical cost of doing a rebuild and what should I look for when it is taken apart? Thanks in advance.

  2. #2
    it can vary from a piston to a complete rebuild and crank .
    tear it apart and inspect or if you want go big and figure a new Hotrods crank 500 $a full piston / gasket kit like pro-x 350$ and then a bore 35$ x 3
    then unless you know how your carbs are figure 3 40$ carb kits
    and go premix while your at it

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. RXP engine rebuild
    By aha in forum 4-Tec Performance
    Replies: 5
    Last Post: 08-26-2005, 04:59 PM
  2. RXDI top end rebuild
    By bow tie klr in forum Sea Doo Open Discussion
    Replies: 0
    Last Post: 08-04-2005, 08:02 AM
  3. RXP engine rebuild
    By aha in forum 4-Tec Performance
    Replies: 7
    Last Post: 07-29-2005, 02:16 PM
  4. July 2005 Supercharger rebuild kit! (sunfunzoom)
    By MikeTrin in forum 4-Tec Performance
    Replies: 16
    Last Post: 07-22-2005, 09:40 PM
  5. needle bearings on rebuild kit
    By RXPNJ in forum 4-Tec Performance
    Replies: 2
    Last Post: 07-15-2005, 08:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts