Thread: No umi-this is what i did
10-29-2008, 07:12 PM #1
No umi-this is what i did
This is the best i could do. Finger throttle, pro taper bars, 08x switch block, rox 5" risers. I took apart my steering & polished & clear coated with wheel paint. I am happy with it. Not as nice as the umi, but certainly cheaper.
10-29-2008, 07:20 PM #2
10-29-2008, 07:56 PM #3
Nice garage full of toys
10-29-2008, 08:03 PM #4
not in the pic:
67 435hp vette coupe
66 425hp vette conv
10-29-2008, 08:04 PM #5
NIce! What was the total cost & How did it handle?
10-29-2008, 08:09 PM #6
10-29-2008, 08:15 PM #7
I won't be riding until spring.
I am always standing when i ride my sled so i find myself doing this on my rxp which causes a sore back so i raised the bars.
Canadian $ (sucking right now)
$65. For the bars
$150. For the switch block
$80. For the finger throttle
$70. For the risers
$0. For the labour
10-29-2008, 09:33 PM #8
10-29-2008, 09:36 PM #9
10-30-2008, 05:22 AM #10
Good Job ... I like it ... where did you get the start/VTS switch for the X model ?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By greens1098 in forum 4-Tec PerformanceReplies: 12Last Post: 04-04-2010, 02:46 PM
By ZMANN in forum Polaris Open DiscussionReplies: 38Last Post: 08-27-2006, 07:22 AM
By oneal in forum Sea Doo Open DiscussionReplies: 9Last Post: 07-29-2005, 06:42 AM
By Water4fire in forum 4-Tec PerformanceReplies: 12Last Post: 05-20-2005, 07:22 AM
By Jrsrxp in forum 4-Tec PerformanceReplies: 1Last Post: 04-30-2005, 10:25 AM