11-03-2008, 08:41 AM #1
X Nozzle / Venturi compared to RXP nozzle
Just wanted confirmation, but checked in the store and the Pro Series Nozzle says good for X boats and standard RXP.
Are the exit nozzles (venturi) the same for the X boats and the RXP?
I am going to have 2 made by Diggs but wanted to make sure that a stock RXP nozzle will fit my RXT-X so I can get it machined to accept the rings.
11-03-2008, 04:05 PM #2
11-03-2008, 09:01 PM #3
11-10-2008, 05:18 PM #4
What size is the stock nozzle of the RXT-X, and the RXT?
11-10-2008, 05:40 PM #5
If i am correct the standard RXP/T is 83mm and the X- boats are 86mm
11-10-2008, 07:58 PM #6
yes, sno is right...
the x nozzle is bigger diameter (86mm) and shorter vs the stock rxp (83mm) nozzle. there are pics floating around on this site where you can clearly see the difference.
both nozzles work on the rxpx in spite of the difference (without having to modify anything)
11-10-2008, 08:37 PM #7
The X nozzle is 86.95mm. At least the one I just measured.
11-11-2008, 10:04 AM #8
11-12-2008, 10:04 PM #9
Stock 83 nozzle , X nozzle, pro nozzle
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gms05rxt in forum Sea Doo 4Tec SkisReplies: 3Last Post: 04-18-2013, 02:00 PM
By Water Pig in forum 4-Tec PerformanceReplies: 19Last Post: 03-28-2010, 07:44 PM
By sweetbats in forum Sea Doo ClassifiedsReplies: 5Last Post: 11-29-2008, 03:01 PM
By vxrpete8 in forum Sea Doo ClassifiedsReplies: 3Last Post: 07-07-2008, 10:44 PM
By dv8rxp in forum Sea Doo ClassifiedsReplies: 2Last Post: 06-02-2008, 07:21 PM