Results 1 to 5 of 5
  1. #1
    SpeedFreak
    Join Date
    Jul 2008
    Location
    Fond du lac Wisconsin
    Posts
    220

    Sealing for dplate?

    It says in the instructions that you should use threebond 1211 for sealing up dplate when put back together. I dont have any of that laying around but I do have threebond 1194 instead. Will this work? Also seeing as I have the whold exhaust apart am I supposed to get new gaskets or can I just use the 1211/1194?


  2. #2

    Join Date
    May 2008
    Location
    Savannah, GA
    Posts
    452
    I didn't use any sealant at all. I put a light coat of grease on my old gaskets and reused them.

  3. #3
    Altezza01's Avatar
    Join Date
    Jun 2007
    Location
    Destin, FL
    Posts
    1,527
    +1
    13
    i didnt use sealant either. just put my finger in some oil and smoothed it on the same gasket

  4. #4
    SpeedJunky's Avatar
    Join Date
    Dec 2005
    Location
    Michigan
    Posts
    1,118
    +1
    35
    As long as the gaskets are not damaged you can reuse them.
    Spray them with Permatex copper spray-a-gasket, it's a hi-temp sealer.
    I have done this on 3 of my boats with no problems.

  5. #5
    Moderator OsideBill's Avatar
    Join Date
    Mar 2006
    Location
    United States
    Posts
    11,875
    +1
    30
    I reused the OEM gaskets with a light coat of grease never had an issue, I have done this on many skis.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FS Rad4 driveshaft seals for - RXP/RXP-X/RXT/RXT-X/GTX
    By Gus13letter in forum Sea Doo Classifieds
    Replies: 30
    Last Post: 09-28-2009, 08:09 AM
  2. Replies: 3
    Last Post: 09-08-2009, 10:15 PM
  3. Grease seals for my Yacht Club trailer?
    By tenjuna in forum Towing and Trailers
    Replies: 1
    Last Post: 07-21-2009, 08:20 PM
  4. Grease seals for my Yacht Club trailer?
    By tenjuna in forum Polaris Open Discussion
    Replies: 0
    Last Post: 07-20-2009, 02:09 PM
  5. grommet/rubber seal for driveshaft?
    By jahkneefive in forum Sea Doo Open Discussion
    Replies: 0
    Last Post: 07-20-2007, 08:09 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •