Thread: motor shims
11-06-2008, 04:55 PM #1
i'm replacing the bonded coupler with a solid and could use some shims just in case
11-06-2008, 09:38 PM #2
You should be fine but if you need the shims, I think it was BD that was making them.
11-08-2008, 07:26 PM #3
just need a few used shims in case the motor needs to be move to get the alignment better
11-09-2008, 04:01 AM #4
- Join Date
- Jul 2007
- Cedar Rapids,Iowa
Check with Jay,he may have some from the skis with the blown motors.
11-09-2008, 08:57 AM #5
TX I can send you some that I cut on the laser.. They are plastic and work great I needed to use 6 of them yesterday.
11-09-2008, 10:04 AM #6
i have lots of OE ones here, i could send you an assortment ( if BD can't)
send me an email with your addres info, and i can get them right out.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By TheEngineer in forum 4-Tec PerformanceReplies: 3Last Post: 09-01-2012, 07:49 PM
By splawnrw in forum 2-Stroke PerformanceReplies: 2Last Post: 08-06-2009, 09:33 PM
By beachbum0286 in forum Sea Doo ClassifiedsReplies: 1Last Post: 04-20-2009, 05:16 PM
By abarrassr07 in forum 2-Stroke PerformanceReplies: 6Last Post: 11-16-2008, 09:36 PM
By RHeller1 in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 07-10-2008, 06:52 AM