Results 1 to 3 of 3
  1. #1
    HBILLYJET's Avatar
    Join Date
    Feb 2007
    lost in space"danger Will Robertson''

    removing driveshaft from waverunner III

    After removing to impeller from the drive of a waverunner(92) the manual is vague it's say to press it out but in trying I heard a POP! is there anything else I do after removing the cone besides just puting it in a press and pressing the shaft out.

  2. #2
    It doesn't press the way u would think! you need to press the long side of the shaft thru the housing and out the cone end most presses won't accommodate this , so support the housing and drive it out with a brass / sand hammer! installation is way easier post back for the trick

  3. #3

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 14
    Last Post: 02-14-2010, 07:14 AM
  2. removing driveshaft from waverunner III
    By HBILLYJET in forum Yamaha How To & FAQs
    Replies: 2
    Last Post: 11-07-2008, 05:11 PM
  3. Replies: 4
    Last Post: 10-27-2007, 06:05 PM
  4. Remove driveshaft from pumphouse?
    By ExciterGPR in forum Yamaha PWC Performance (2-stroke)
    Replies: 13
    Last Post: 03-04-2006, 01:02 AM
  5. Removing scratches from gelcoat
    By Yuji in forum 4-Tec Performance
    Replies: 2
    Last Post: 06-01-2005, 09:02 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts