11-12-2008, 11:54 AM #1
Tip of the day: Shimming Supercharger Clutch
To keep your ski running at it's peak performance it's often necessary to shim the supercharger clutch to prevent slippage.
The shims go in between the spring washers as shown in this picture
If your clutch components are really worn you might find it necessary to install two shims. Sometimes you will find that two shims is too much but one is not enough. If the clutch is too tight with two shims what you can do it mill down the L ring on a piece of emery cloth or sand paper.
The L ring is the collar that goes on the shaft just before the nut
What i do is rub it back and forth on some emery cloth about 10-15 times, reassemble and check the slip. Sometimes it's necessary to mill it down a couple of times until you get the slip fine tuned.
Hope this was helpful to some of you
11-12-2008, 12:06 PM #2
I was just visting with Jim about this yesterday.
Its allways helpful to us that dont know.
Yes there are still some out here that learn something everyday.
11-12-2008, 12:08 PM #3
11-12-2008, 01:31 PM #4
11-12-2008, 01:43 PM #5
11-12-2008, 01:49 PM #6
It's just a Nikon D40 with a macro lens that Mike and Hydrotoys recommended to me. The lens is a Nikon 60mm f/2.8G AF-S Micro whatever all that mumbo jumbo means
11-12-2008, 02:14 PM #7
11-12-2008, 02:28 PM #8
11-12-2008, 02:32 PM #9
NEED TO USE THAT LENS FOR SOME CLOSE UPS OF A FEW LADIES
11-12-2008, 03:44 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo How To & FAQsReplies: 22Last Post: 06-21-2014, 02:15 PM
By Gunna in forum Yamaha PWC Performance (4-stroke)Replies: 7Last Post: 07-14-2011, 12:34 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 49Last Post: 01-21-2009, 09:46 AM
By Green Hulk in forum Sea Doo How To & FAQsReplies: 28Last Post: 08-24-2007, 11:52 AM
By carbuff91 in forum Yamaha PWC Performance (2-stroke)Replies: 16Last Post: 07-16-2006, 11:37 AM