Thread: Aussie damian's new begining
11-22-2008, 07:27 PM #1
Aussie damian's new begining
Well i dont want to name names but this ski was suppose to be water ready and crated to australia. Never the less it was never ready for the water and never started.
I was given the honors to transform this mess into a everyday runner. =d> =d>
so here goes the story.
I will post before and after picks so you can see the progress of the ski.
The hull cuts were hideous never smoothed nor sealed so water could come between the layers. Wires were all rigged up poorly.
Mr. Damian enjoy your new ski
11-22-2008, 07:29 PM #2
Now for the proper hull cuts. I hate doing hull cuts as you can see it makes a mess.
11-22-2008, 07:30 PM #3
11-22-2008, 07:33 PM #4
I am glad its in the right hands now and starting a new chapter as they say.
Jay enjoy the build....
11-22-2008, 07:34 PM #5
Once the resin dries i will sand it and apply another layer sand it smooth and then paint it. Install the engine and align the engine. Then i will be able to move onto the drive line. I dont take short cuts because they bite you in the ass in the long run. I want this ski to be a pleasure for him not a nightmare.
11-22-2008, 07:34 PM #6
11-22-2008, 07:35 PM #7
11-22-2008, 07:35 PM #8
I WANT TO HAVE BOTH DONE FOR LATE DEC SO YOU GUYS CAN MAKE THE RACE..
11-23-2008, 06:02 AM #9
11-23-2008, 10:29 AM #10
haven't shaved since the Hydrodrags?
Your ski is in the right hands Damian
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By thomase87 in forum Yamaha PWC Performance (2-stroke)Replies: 31Last Post: 03-08-2010, 10:33 AM
By Mik72e in forum Kawasaki PWC Performance (4-stroke)Replies: 34Last Post: 11-11-2009, 03:52 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 38Last Post: 01-01-2008, 10:50 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 34Last Post: 05-12-2005, 08:56 PM
By racerrob333 in forum Sea Doo Open DiscussionReplies: 8Last Post: 05-04-2005, 03:45 PM