11-28-2008, 07:48 PM #1
wtb:Rod pin, 24x56 mm,or longer needed!
Anyone have one? Any ideas where I can locate one..? hot rods?crankworks?
I have a wr crank I purchased very cheap, with new rods and bearings already installed ,it was pressed together poorly and galled the hole it was pressed into...I have a replacement for the ruined crank part(doner crank), just need a rod end pin to press this together and retrue...
24 mm by 56mm ....longer is accepable as i can mill this down to correct length ..
even a 'perfect' used one may be accepable..thanks!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By keith neff in forum Polaris ClassifiedsReplies: 1Last Post: 06-10-2009, 10:35 PM
By w/rpm500 in forum Yamaha Old School SkisReplies: 4Last Post: 11-30-2008, 09:26 AM
By xBigDaddyx117 in forum Sea Doo ClassifiedsReplies: 1Last Post: 11-08-2008, 03:46 PM
By dustin88 in forum Polaris ClassifiedsReplies: 0Last Post: 08-06-2008, 02:20 PM
By wreckmaster in forum Polaris ClassifiedsReplies: 3Last Post: 05-13-2008, 11:31 PM