Thread: Rod pin ..anyone have one?
11-28-2008, 09:11 PM #1
Rod pin ..anyone have one?
needing a 24 mm x 56mm (longer is ok)
know where to get one?I have an email in to phil at crankworks already...
11-29-2008, 07:17 PM #2
if any one is looking for crank pins ,bearings or thrust washers ....wiseco.com
below is a link for their pdf chart
11-29-2008, 11:58 PM #3
I will look..do you still need one? What piston did this go on?
11-30-2008, 01:40 AM #4
wasn't the piston end I'm needing, it's the solid big end pin (crank side)... they list them and are available, in stock.
I got a wr crank for next to nothing ,that was a fresh rebuild gone bad. Whom ever did the build, galled the flywheel side of the big end pin while pressing.. I have a core crank that had a perfect end piece ,so it will be a an easy fix with a new pin and rod thrust washers...
I will then have a spare crank when needed..
11-30-2008, 09:26 AM #5
- Join Date
- Aug 2006
I'm getting ready to buy a hotrods for my spare 760 motor that I'm building! I love spares
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By o0 RASTA 0o in forum Yamaha Old School SkisReplies: 11Last Post: 07-08-2009, 08:38 AM
By HallPass in forum Other ToysReplies: 58Last Post: 05-21-2008, 02:40 PM
By Water4fire in forum Sea Doo Open DiscussionReplies: 4Last Post: 10-13-2006, 01:51 PM
By Water4fire in forum 4-Tec PerformanceReplies: 7Last Post: 09-13-2006, 05:38 PM
By Angelse68cal in forum Sea Doo Open DiscussionReplies: 2Last Post: 08-10-2005, 04:08 PM