Thread: Riva 2* Pump Wedge
12-02-2008, 10:37 PM #1
Riva 2* Pump WedgeMy pump wedge has been installed but after looking in the shop I noticed that the R&D wedge comes with a cable extension as well. Is this to allow for the reverse lever to stay flush when in forward? I have noticed that with my wedge installed the reverse lever does not lower all the way and sits slightly high when in the forward position. Can I just buy the cable extension without purchasing an entire kit?
12-02-2008, 10:43 PM #2
The R & D is a 2.5 degree... thats why it has the extension.
Try adjusting you reverse cable turnbuckle at the pump... just don't get below 3-4 threads when unscrewing!!!
12-02-2008, 10:46 PM #3
You can adjust your reverse bucket where the cable attaches. There is a 10mm lock nut. Loosen the nut and adjust the fitting on the cable.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gba in forum Sea Doo ClassifiedsReplies: 4Last Post: 07-17-2008, 07:38 PM
By RudyJ in forum 4-Tec PerformanceReplies: 4Last Post: 01-07-2008, 09:00 PM
By catchme in forum 4-Tec PerformanceReplies: 22Last Post: 02-03-2007, 09:56 AM
By North49 in forum 4-Tec PerformanceReplies: 14Last Post: 10-06-2006, 09:18 AM
By majundecid in forum 4-Tec PerformanceReplies: 6Last Post: 07-08-2006, 06:52 PM