Thread: RXT-X problem
12-08-2008, 07:18 AM #1
I have a problem with an RXT-X that I cannot figure out.
We just did a teardown (SC cleaning ect) and installed the 15/22 and manifold upgrade last weekend. The ski will not push past 6600 RPM and pulls hard up to there. Hoses tight, SC washers perfect, no manifold leaks.
What is holding this rocket back?
12-08-2008, 11:43 AM #2
12-08-2008, 11:54 AM #3
12-08-2008, 12:23 PM #4
6600 RPM's sure sounds like an SC problem. Did you change the clutch washers while you had it apart?
12-08-2008, 12:36 PM #5
The washers have 70 hours on them, I checked the slip and it was within spec. This ski ingested some water from a leaking I/C but valves and TB looked fine.
We are going to check everything over and try a new set of plugs.
Would a code/warning appear if the limp mode was engaged?
12-08-2008, 05:04 PM #6
If it was in limp mode you wouldn't see 6600 rpm.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By RXT817 in forum Sea Doo Open DiscussionReplies: 3Last Post: 08-20-2009, 01:23 PM
By Phil in forum 4-Tec PerformanceReplies: 4Last Post: 03-27-2009, 04:13 PM
By gms05rxt in forum 4-Tec PerformanceReplies: 11Last Post: 02-18-2009, 07:48 PM
By YoYamma in forum 4-Tec PerformanceReplies: 8Last Post: 07-20-2008, 08:55 PM
By marcelaw97 in forum 4-Tec PerformanceReplies: 7Last Post: 05-29-2008, 11:54 AM