Thread: Advent settings
03-31-2006, 08:11 PM #1
- Join Date
- Jan 2006
- Ft. Walton Bch
What are the recommended settings for the Advent 1290 D70? in a single piper? 2000 GPR .
Curve yam 83,94,59,or 84
Power valve snap 56,58,60,61?
03-31-2006, 09:19 PM #2
- Join Date
- Apr 2006
- panama city beach 'fl
went thru this last week i was told 84curve snap 56
03-31-2006, 09:34 PM #3
hmmm, out of curiosity, how do you change the curves as I only saw for the rev limiter, pipe setup, power valves setup. I have a switch a and a switch b and the two have 6 switches.
03-31-2006, 11:23 PM #4
I liked Yam59, snap 58. Worked well on a stage 2 GP1200R
04-01-2006, 05:36 AM #5
05-19-2006, 04:20 PM #6
For the Yam-59 and Yam-84 it recommends to change jets. But, for Yam-04 you don't need to rejet. I'm not sure if have the t-handle adjusters will compensate for needing to rejet or not...anyone???
05-19-2006, 06:57 PM #7
I would definately rejet. If your engine is nonported and you have flame arrestors on it see below. I would rejet for the ignition alone anyway. And as a side note always use fresh 92 octane gas.
Used the tried and true Fercho jetting for 1200's
Low speed adjusters 7/8 to 1 turn
High speed adjusters 1 1/2 to 2 turns
05-19-2006, 08:04 PM #8
Where the hell do you get 92 octane in california spud?
05-20-2006, 03:33 PM #9
So, the T-handles don't do enough??? Damn, I should have rejetted when the carbs where rebuilt!!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By PolarisNut in forum Yamaha ClassifiedsReplies: 4Last Post: 08-17-2012, 09:39 AM
By MPower in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 12-02-2008, 10:11 PM
By HallPass in forum Yamaha PWC Performance (2-stroke)Replies: 14Last Post: 02-01-2008, 02:15 PM
By dhoad in forum Yamaha PWC Performance (2-stroke)Replies: 41Last Post: 07-30-2007, 08:55 AM
By mickey78 in forum Sea Doo Open DiscussionReplies: 8Last Post: 07-20-2005, 11:59 AM