Thread: Metal Pump Upgrade Questions
12-28-2008, 08:48 AM #1
Metal Pump Upgrade Questions
I have all the parts to do this upgrade now and I was wondering if anyone who had already done the upgrade could give me some tips before I get started. I do have a couple specific questions:
1) Any tips on the specific assembly sequence (seal and bearing side)?
2) I don't have a press right now, is there any problem with installing the bearing with a dead blow hammer on the outer race?
Any other assembly advice would be greatly appreciated.
12-28-2008, 09:32 AM #2
I'm pretty sure that you should apply pressure to the inner race only. Maybe use a deep well socket or length of pipe and strike that. But I would not strike the outer race... Ron
12-30-2008, 09:00 AM #3
Thanks Ron. No one else has done this? Any other tips on assembly?
12-30-2008, 10:20 AM #4
Sorry, no. PPG assembled the metal pump when it was replaced under warranty, and shipped it back ready to go.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Deerefly in forum Polaris How To & FAQsReplies: 1Last Post: 04-08-2013, 10:02 AM
By chazdo2 in forum Polaris How To & FAQsReplies: 9Last Post: 05-28-2011, 11:54 PM
By thompsdw in forum 4-Tec PerformanceReplies: 7Last Post: 09-28-2008, 10:31 PM
By great lakes gpr 1200 in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 03-28-2007, 03:31 AM
By MikeTrin in forum Sea Doo Open DiscussionReplies: 5Last Post: 09-04-2006, 06:58 PM