07-10-2005, 09:31 AM #1
Pics of S.C. Gear after clutch failure
Make sure you guys check your gear...And your sc shaft as well...You should have four defined impressions on each side...Make sure that the metal on the gear has not been dragged into these impressions..As well check the base of the shaft for wear marks as well...should be perfectly smooth on the base of the shaft as well...
Hope these pics help...
07-10-2005, 10:31 AM #2
Were your clutches missing when you pulled the SC out?
07-10-2005, 10:58 AM #3
- Join Date
- Apr 2005
- Augusta GA
Also is this your stock gear and is this the first time you have pulled your SC??
07-10-2005, 06:05 PM #4
lost 2 washers...Ran boat for about 4 mins after she blew...I run the rxp sc gears in my gtx...7% more boost for me..
07-10-2005, 08:27 PM #5
- Join Date
- May 2005
- Fredericksburg, VA
What did you gain with those gears? Any need for a different ECU. I have a set of rxp gears I have been thinking about putting in. As a matter of fact I would really like to stick the gears, intercoller and Ecu on it and turn it into a RXT
07-10-2005, 08:36 PM #6
07-10-2005, 08:55 PM #7
stock sc...Home made...I am not entirly sure if you can run the rxp gears without the ecu...I think that the stock ecu would compensate but you should ask Mark @ race tech first...New sc clutch setup Race tech prepped...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By TW - Twisted Wrench in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 06-06-2012, 11:23 AM
By SplishSplash in forum 4-Tec PerformanceReplies: 5Last Post: 08-27-2006, 08:03 AM
By MikeTrin in forum Sea Doo Open DiscussionReplies: 52Last Post: 02-06-2006, 07:38 AM
By Big Red Monster in forum 4-Tec PerformanceReplies: 11Last Post: 08-30-2005, 08:22 PM
By RXDI2 in forum 4-Tec PerformanceReplies: 4Last Post: 08-16-2005, 12:14 PM